Although OBS is not such a popular company, and they do not release devices so often, but you can not often hear anything bad about them, because they make devices of good quality, which is not so often found in the Chinese. This time their range was supplemented with the Engine RTA, and I will tell you more about it.
Engine RTA by OBS
The design of the device gives me contradictory feelings: I really like the bottom part, but the top part causes wild disgust. canadian vape shop montreal To be more precise, I don’t like the step where the airflow hole is located, I wish they made it the width of the body, it would be much better. Otherwise, the tank diameter is 25mm and the body is available in black and steel.
Engine RTA by OBS
All the most interesting things are inside the tank. I’ll start with the base, which is a velocity rack. At the bottom of the base there are 4 holes for absorbent cotton, through which the liquid will get into the vaporization chamber. The most interesting thing is that the liquid in this tank comes in the same way as in any other tank with the bottom location of the liquid reservoir, but here it is not from the bottom, but in the usual location. Why it was done this way is not clear. Filling the tank is standard for OBS, you pull off the cap and fill it into the hole on the side. The volume of the tank is 5.2 ml, which is not so little.
The airflow here is top airflow, as it is impossible to fit any other airflow here due to the peculiarities of the base. I see only one plus in such airflow – complete absence of leaks. But the flavor transfer suffers from it, though OBS assures that everything is fine here.
Engine RTA by OBS
Quite an interesting tank, which left a lot of questions. I still don’t understand why to make a tank with liquid supply like tanks with bottom filling? The only explanation I can see for myself is Archimedes’ law, which means that the liquid will tend to come to the same level, so there shouldn’t be any problems with the vaporization chamber, the main thing is not to put too little wool, so that the vaporization chamber doesn’t fill up completely!